Using Packet Tracer for Small LAN Setup

Project: Using Packet Tracer for Small LAN Setup Question1 Consider the network topology shown below. Use the Packet Tracer software to perform the following tasks: a. Set up equipment to match the network topology. b. Configure the IPv4 address, subnet mask, and default gateway address for PCA. c. Ping the default gateway address from a PC-A command prompt. Were the pings successful? Why or why not? Answer: Question2 d. Configure and enable the G0/1 interface on the router e. Ping the default gateway address of R1 from PC-A. Were the pings successful? Answer: Question3 a. Write down the command you use to display the MAC address for of PC-A. Write down the MAC address of PC-A. (convert in binary byte separated) b. What is the MAC address for G0/1 on R1?. (convert in binary byte separated) c. What is the MAC address for F0/5 and F0/6 on your switch? (convert in binary byte separated) Answer: Required Resources: • 1 Router (Cisco 2811) • 1 Switch (Cisco 2960) • 1 PC • Console cables to configure the Cisco devices via the console ports • Ethernet cables as shown in the topology © 2015 College of Computer Information technology Page | 1 of 2 Note: 1.Your answers should include images From Packet tracer. 2.Put your Answer file and packet tracer file in a folder named LAB6; Zip the folder and upload the zipped folder. © 2015 College of Computer Information technology Page | 2 of 2